This mould is the second step of a slumping process which is done in a total of 3 steps.
The final piece is a vessel of glass diam. 26 cm, depth 18 cm.

Special firing information:
Step I See instructions Mould 958.410
Step II: The shallow slumped piece will be placed into this deeper to allow the glass to stretch but not "fall".
The result of this step is a deep piece of glass with no base.
This is a tricky process, very even heat distribution is necessary.
The ideal slumping temperature may vary depending on the viscosity of the glass.
Step III: See instructions Mould 958.412.

Recommended firing charts and instructions for all steps are based on information received from Karl Harron, Ireland, www.theglasstudioireland.com

Creative Ceramics code: 958.411
Bullseye code: 8451
TGK code: 3522731

Inner Dimensions: Diameter: 32.5 cm, Height: 13.5 cm
Outer Dimensions: Diameter: 35 cm, Height: 14.4 cm